Post
What to Verify When Replacing a Side-Channel Blower
Replacing a side-channel blower? Check pressure or vacuum duty, airflow, relief devices, filtration, cooling, controls and site fit first.
Towwind Technology
Post
How to Select an Energy Saving Blower: A Seven-Step Engineering Method
Selecting an energy saving blower starts with the process result: what must be dried, aerated, cleaned, cooled or conveyed, and under which production condition? Convert that result into an airflow-pressure operating point, then check the air path, operating modes, electrical supply, controls and installation environment.
Post
How to Compare 220 V and 380 V Blower Options
Compare 220 V and 380 V blower options by site supply, installed cost, air performance and measured energy use—not voltage alone.
Post
Responding to a Blower Alarm Without Losing Diagnostic Evidence
Respond safely to a blower alarm while preserving fault codes, operating conditions and trend data. Avoid resets that erase useful diagnostic evidence.
Post
Why Do Plated Parts Remain Wet After Air Drying?
Trace residual water on plated parts by its location and timing, then check part geometry, nozzle reach, drainage and mist before changing blower settings.
Post
Pipe Strain and Flexible Connections in Blower Installation
Learn how pipe strain and flexible connections affect blower installation. Check supports, alignment, vibration and air-path performance before acceptance.
Post
What Site Data Should You Collect Before Replacing a Wastewater Aeration Blower?
Prepare a wastewater aeration blower replacement survey: record existing equipment, basin duty, pressure, airflow evidence, controls and missing measurements before requesting a proposal.
Post
How Does an Energy Saving Blower Work? Motor, Control and Air Delivery
An energy saving blower converts electrical input into controlled airflow through a high-speed motor, drive electronics and an impeller matched to the casing. Towwind uses BLDC motor technology, so output can be adjusted electronically instead of relying only on a fixed-speed motor and mechanical throttling.
Post
Checking Electrical Supply Before Blower Startup
Check blower electrical supply before startup: match the exact model, voltage, phase, frequency, protection, grounding and controls, then record test results.
Post
How PCB Air Knife Drying Works: Water Removal in Stages
PCB air knife drying works by converting blower air into a controlled high-velocity sheet that pushes liquid across and off the board. The first stage removes bulk water; later stages clear the remaining film and droplets from surfaces, edges and holes.