Post
What to Record During the First Blower Test Run
Know what to record during the first blower test run: operating mode, airflow evidence, pressure, electrical input, alarms and process results.
Towwind Technology
Post
What Data Should You Record Before Reporting a Blower Airflow Drop?
Prepare a blower airflow drop support report with comparable operating conditions, tagged pressure or airflow readings, alarm history and the information a supplier needs.
Post
When Should You Replace a Side Channel Blower? A Maintenance Decision Guide
A side channel blower should be replaced when the combined risk of failure, process loss, energy waste and repair delay exceeds the risk and installed cost of a planned retrofit. Age alone is not enough. A well-maintained older blower may remain serviceable, while a newer but misapplied unit may deserve early replacement.
Post
Verifying Control Signals and Alarm Wiring Before Commissioning
Verify blower control and alarm wiring before commissioning. Check commands, feedback, fault response and test records on the assembled machine.
Post
What Is the Best Blower for an Air Knife Drying System?
The best blower for an air knife is not always the model with the highest pressure, the largest airflow or the biggest motor. It is the blower that supplies the required air to every active knife, at the installed resistance, while meeting the line’s drying or blow-off target with reasonable energy use and service risk.
Post
Sizing a Blower for Continuous-Duty Equipment
Learn how to size a blower for continuous-duty equipment using actual airflow, pressure, temperature, cooling and input power—not motor kW alone.
Post
Control and Alarm Interfaces to Check During a Blower Retrofit
Before a blower retrofit, check start commands, speed references, run feedback, fault alarms and machine interlocks against the exact controller manual.
Post
Drying Containers and Packaging with Industrial Air Knives
Evaluate industrial air knives for container drying before labeling, coding or packing. Check wet spots, line speed, changeovers and blower power.
Post
Can a 1.5 kW Blower Replace a 4.0 kW Ring Blower? Evidence Required
Replacing a 4.0 kW ring blower with a 1.5 kW unit is possible only when strong evidence shows that the old machine has substantial unused capacity. The power-class gap is large enough that a buyer should treat TW1500B as one candidate, not as the default energy-saving replacement.
Post
Where to Place Filters, Valves and Pressure Measurement Points
Plan blower filters, valves and pressure taps around the actual air path. Learn which readings protect the unit, verify process air and aid maintenance.